Seamaster Paint


Luxury Silky Wall Finish

Seamaster Higlos Luxury Silky Wall Finish is a smooth and easy-to-apply wall ¬finish specially formulated to protect and decorate interior surfaces. It forms a tough film that is washable, good adhesion onto previously painted surfaces, good alkaline and fungus resistance, good gloss retention, excellent colour fastness and quick drying. It is a low odour, low VOC, APEO free and Formaldehyde free product. It passed / complied with all requirements under Singapore Green Labelling Scheme (SGLS).

Specially formulated for protection and decoration of interior masonry and other surfaces such as plaster wall, cement, gypsum board, brickwork, hard and soft boards and on appropriately primed wood surfaces.

Product Specifications
Physical Characteristics
Ingredient :
  • Modified acrylic emulsion
  • Colour pigments
  • Mineral extenders
  • Additives
Density : 1.10 – 1.30 (kg/litre)
Solid : Approximately 45 %
Coverage : 11 – 13 m² /litre
Colours : A wide range of colours. Please refer to colour card and fandecks.
Gloss : Glossy
Dry Film Thickness : 25 – 30 microns per coat
Drying Time  
(27±2°C & RH: 80±5%) : Touch dry : ≤ 30 minutes
Hard dry : ≤ 1 hour
Recoating Interval : 3 hours
Theoretical Coverage : 11 – 13 m² / litre
No. of Coats : Minimum 2 coats
Application Method
Method of Application :
Brush, roller and spray application.
Product Preparation :

Ready for use after thoroughly stirring. However, if thinning is required, not more than 5% of water may be added for the first coat. For best result, thinning is not recommended for the subsequent coats.

Surface Preparation
New Mansory Surface :

It is crucial that ample time is allowed for the concrete / plaster surfaces to dry out. High moisture content is a common cause for premature paint failures, such as blistering, discolouration, etc. Concrete / plaster are alkaline in nature and together with the presence of salts and moisture may cause paint systems to fail prematurely. Masonry surfaces must be reasonably and free from oil / grease and other contaminants before an appropriate alkali resistance sealer is applied.

Old Unpainted / Previously Painted Masonry Surface : Surface must be dry and free from any structural damages and cracks. Wash the surface to remove any vegetable growths, stains, debris and powderiness by high pressure water jets. Seamaster FW 103 Fungicidal Wash should be used as a wash and left for 48 hours before nal rinse with clean water. This will ensure most fungus spores are killed.

For old paint work that is sound and has good adhesion, wash o dirt and surface powder with clean water or brushing before painting with Seamaster Higlos topcoat. For poor paint work which is powdery, chalky and poor in adhesion, it is crucial to remove the paint work by scraping or by brushing with sti bristle brush before the full painting system is applied.

Storage Condition
Air tight, under dry and cool condition.

Low Odour
APEO & Formaldehyde Free

Main Product Feature

  • 80% glossy finish
  • Washable
  • Excellent adhesion & durability
  • Excellent colour fastness
  • Fungus and algae-resistant
  • Excellent hiding power
  • Smoother finish
  • Dirt-resistant formula